QuickStart

QuickStart provides cards for common security goals. Each card applies several compatible settings together; its page says which settings change, what the resulting protection or logging does, and which important cases remain outside it. Some cards only report status and do not apply settings. QuickStart can remain the main settings interface, or you can move between it and Advanced settings. Merely switching interfaces does not apply or reset any setting.

In Premium, the most recently applied UI change wins. Changing an individual setting in Advanced settings takes effect even if a selected card previously set it, so the card can remain selected while its bundle no longer describes all the effective settings. Changing a card’s state then becomes the latest UI change: selecting it applies the bundle, while deselecting it restores the prior values that card owns. Explicitly saving QuickStart reasserts selected cards. QuickStart owns only settings it changed; compatible values that were already present remain independent, and a complete bundle configured independently can appear as started and locked.

In Free, Advanced settings is a read-only display of the individual controls. Selected QuickStart cards continue to supply their values, and individual Free values can be changed only through constants.

Constants take priority over both interfaces in either edition. Changing a constant can override an Advanced setting and can prevent an enabled QuickStart card from applying its bundle. When any fixed value conflicts with a card, QuickStart applies none of that card’s changes, and Site Health can report the conflict. An already compatible constant may satisfy a card without being changed; some cards therefore accept a stronger value than the value they would otherwise set.

Examples

These examples use Advanced username protection, which requires both user-enumeration protection and email-only login to be on. The tables show the effective values after each action.

Latest Premium UI change

Start with both settings off, then apply the card and edit email-only login in Advanced settings:

Action

User-enumeration protection

Email-only login

Initial values

Off

Off

Select the card

On

On

Save email-only login as off in Advanced settings

On

Off

Open QuickStart without saving it

On

Off

Save QuickStart with the card selected

On

On

The Advanced edit takes effect because it is the later UI change. Opening QuickStart does nothing by itself; saving it reasserts the selected card.

Values the card owns

Now start with user-enumeration protection already on and email-only login off:

Action

User-enumeration protection

Email-only login

Initial values

On

Off

Select the card

On

On

Deselect the card

On

Off

The card leaves the compatible user-enumeration value independent. It owns the change to email-only login, so deselecting the card restores only that setting.

Compatible and conflicting constants

With both saved UI values off, define WP_FAIL2BAN_BLOCK_USER_ENUMERATION as true:

Action

User-enumeration protection

Email-only login

Before selecting the card

On

Off

Select the card

On

On

Deselect the card

On

Off

The constant satisfies one requirement without being changed or owned by the card. The card changes and later restores only email-only login.

If the same constant is false, it conflicts with the card:

Action

User-enumeration protection

Email-only login

Before applying the card

Off

Off

Attempt to apply the card

Off

Off

Remove the constant

Off

Off

Apply the card

On

On

The conflict prevents the whole bundle from being applied, and Site Health can report it. Removing the constant exposes the unchanged saved values; it does not apply the card automatically.